I always hated the feet on my irrigation system. Took up unnecessary space and they filled up with water. Here is my solution.
The 3D Printing Thread
- Thread starter DarkWeb
- Start date
I’m dropping my table on the floor and need to plug the drain. I’ll be pumping out of the table with a micro sump pump in the well.
Initially I was planning on gluing in a plastic plug. @curious2garden came up with a much more elegant 3d printed solution.
Initially I was planning on gluing in a plastic plug. @curious2garden came up with a much more elegant 3d printed solution.
Dboybudz
Dazed and Confused 😛
Nice job,and can be taken out if needed.
Thanks! I'm going to reproduce the bottom part of the bulkhead as well, so I can go back to the old system if I want to. Otherwise I have to chop it off so it can sit on the floor.
Dboybudz
Dazed and Confused 😛
Yea those other pieces are sweet as well, thought of everything,fits perfectly. I'd show the company in a email pic what they need,pay you for design would be awesome. Or probably need patent but still..
Clever
So much cleaner looking.
Done! I had to beef up the clamps a bit. They snapped if they were tightened too much
Bit smaller than the old manifold and should be a lot easier to clean.
She got you too eh?
mine will be arriving shortly. For some reason I thought you had gotten one years ago.
Yup printing replacement people 1 person at a time ;D This is shittier in that you have to print your own replacement but 'murica
at least in body snatchers it was all organic.
I can't leave well enough alone. One more version.
DarkWeb
Probably My Fault
Why?
Will it hide the stains of Floralicious tho
I’m never running floralicious again! Getting that out of the irrigation system was almost impossible!
Yup sea kelp is the main ingredient in floralicious
