Permanent Marker Clone Run

Laughing Grass

Well-Known Menace
Staff Member
Host
Status
Thread author welcomes replies: Yes
Figured I should get the big tent fired up again. This is supposed to be the original Doja Permanent Marker cut just moved into the big tent on Sunday and I'll flip to 12/12 tomorrow and get the irrigation system hooked up by Saturday. Cloning was hit and miss this summer, I think the heat was getting me a bit, so they're not very consistent in size. I'll give the couple taller ones a bit of a trim before flipping.

IMG_2708.webp
 
Under normal circumstances, I think I'd just abandon this journal and pick up on the next grow.

But I figured I'd share my comedy of errors that have roasted this grow.

A little over a week ago I changed the controller for my tent to the new ACI AI controller. Everything went smoothly and I was happy. Then late last week I started noticing problems and they were coming fast. What I discovered is when programming the controller, I somehow managed to set the lights to go off at 10pm as they were before, but the on time was 12am. Only two hours of darkness.

Managed to get that straight and my guardian told me it needs calibration. Get my solution set and the probe will not go below 5ph. The probe can't detect 4.0 solution so it kicks up ERR and won't calibrate. Great! :mad: Ordered a new probe and that's sorted, but I don't think my ph was was in range.

The coup de grace was my condensate pump dying right in the middle of the flush. Over 5 gallons of nutrient solutions on the table and it just died and started spilling onto the floor. :mad: Great again!

Will it recover? Who knows. My clones aren't ready for the big tent yes so I'm just letting it ride out.

IMG_3177.webp
 
Under normal circumstances, I think I'd just abandon this journal and pick up on the next grow.

But I figured I'd share my comedy of errors that have roasted this grow.

A little over a week ago I changed the controller for my tent to the new ACI AI controller. Everything went smoothly and I was happy. Then late last week I started noticing problems and they were coming fast. What I discovered is when programming the controller, I somehow managed to set the lights to go off at 10pm as they were before, but the on time was 12am. Only two hours of darkness.

Managed to get that straight and my guardian told me it needs calibration. Get my solution set and the probe will not go below 5ph. The probe can't detect 4.0 solution so it kicks up ERR and won't calibrate. Great! :mad: Ordered a new probe and that's sorted, but I don't think my ph was was in range.

The coup de grace was my condensate pump dying right in the middle of the flush. Over 5 gallons of nutrient solutions on the table and it just died and started spilling onto the floor. :mad: Great again!

Will it recover? Who knows. My clones aren't ready for the big tent yes so I'm just letting it ride out.

View attachment 9970
It's good you got to document these problems so others know what can happen and to be aware of. Also learned don't need expensive probe can get cheaper one for replacing so that's good. Hopefully they won't reveg on ya and still get something great. I'm thinking you should be good. Always learning..
 
It's good you got to document these problems so others know what can happen and to be aware of. Also learned don't need expensive probe can get cheaper one for replacing so that's good. Hopefully they won't reveg on ya and still get something great. I'm thinking you should be good. Always learning..

I purchased the Aprea Instruments probe. Please to find out that any BNC ph probe works with the guardian. 1/3 the cost of the bluelab probe.


IMG_3119.webp
 
Back
Top